requestHibernate
Request from the ezeio to enter a hibernation cycle
Description
requestHibernate( cycles )
This will cause the ezeio to send a request to hibernate to the servers following the next 10 minute log collection. Please read the section about hibernation modes.
Parameters
cycles | Number of 10-minute cycles before re-connecting to the servers (0=cancel, 1-15) |
Return value
No return value
Example usage
requestHibernate( 6 ); // If server config is set to "Controller Request", the ezeio will hibernate for 6x10 minutes following this command.
NOTE: First appeared in firmware 21100601