Differences

This shows you the differences between two versions of the page.

--- ezeio2:userinterface:configuration:devices:driverlist:discretein [2023-10-13 17:27] – johpar
+++ ezeio2:userinterface:configuration:devices:driverlist:discretein [2023-10-13 18:03] (current) – [Status & Registers (right panel)] johpar
@@ Line 108: / Line 108: @@
 === Available registers ===
-  - Raw electrical signal
+| 1 | Raw electrical value | Unit type is set by "Input hardware type", V, mA, Ohm |
-  - Raw electrical signal
+| 2 | Raw electrical value | Unit type is set by "Input hardware type", V, mA, Ohm |
-  - Scaled value, Register 1
+| 3 | Scaled value, Register 1 | Scaled by 2 point calibration |
-  - Scaled value, Register 2
+| 4 | Scaled value, Register 2 | Scaled by offset and factor |
-  - Logical state
+| 5 | Logical state | Analog value converted to digital (on/off) based on threshold setting |
-  - Logical cycles
+| 6 | Logical cycles | Number of times "Logical state" changes from off to on |
-  - Logical active time
+| 7 | Logical active time | Number of seconds logical state is "on" (runtime) |