ezeio2:userinterface:configuration:devices:driverlist:discretein

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision		 Previous revision
Next revisionBoth sides next revision
ezeio2:userinterface:configuration:devices:driverlist:discretein [2023-10-13 17:23] – [Status & Registers (right panel)] johparezeio2:userinterface:configuration:devices:driverlist:discretein [2023-10-13 18:02] – johpar
Line 33: Line 33:
 **REGISTER 1 & 2 modes** - Each discrete input is duplicated, providing the opportunity apply two modes of initial processing and two methods of scaling. The ezeio controller's microprocessor reads the onboard inputs at a rate of 1000 times per second and exports the results every 1/10 of a second (//connected I/O Expander inputs are sampled slower as they are transmitted via CANbus//). Additional processing is applied to logged registers (see [[ezeio2:userinterface:configuration:fields|"Fields"]]) **REGISTER 1 & 2 modes** - Each discrete input is duplicated, providing the opportunity apply two modes of initial processing and two methods of scaling. The ezeio controller's microprocessor reads the onboard inputs at a rate of 1000 times per second and exports the results every 1/10 of a second (//connected I/O Expander inputs are sampled slower as they are transmitted via CANbus//). Additional processing is applied to logged registers (see [[ezeio2:userinterface:configuration:fields|"Fields"]])
  
-**Register 1 & 2 modes** - Choose one of the setting below for registers 1 & 2.+**Register 1 & 2 modes** - These modes control how the analog to digital converter calculates the live values. //Separate settings on the individual "Field" settings control how each channel is logged//.  Choose one of the setting below for registers 1 & 2.
  
 | **Mode** | **Description** | **Effect** |  | **Mode** | **Description** | **Effect** | 
Line 108: Line 108:
 === Available registers === === Available registers ===
  
-  - Raw electrical signal +| Raw electrical value | Unit type is set by "Input hardware type", V, mA, Ohm | 
-  - Raw electrical signal +| Raw electrical value | Unit type is set by "Input hardware type", V, mA, Ohm | 
-  - Scaled value, Register 1 +| Scaled value, Register 1 | Scaled by 2 point calibration |  
-  - Scaled value, Register 2 +| Scaled value, Register 2 | Scaled by offset and factor | 
-  - Logical state +| Logical state | Analog value converted to digital (on/off) based on threshold setting | 
-  - Logical cycles +| Logical cycles | Number of times "Logical state" changes from off to on | 
-  - Logical active time+| Logical active time | Number of seconds logical state is "on" (runtime) |