Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revisionBoth sides next revision | ||
ezeio2:userinterface:configuration:devices:driverlist:discretein [2023-10-13 17:19] – johpar | ezeio2:userinterface:configuration:devices:driverlist:discretein [2023-10-13 18:02] – johpar | ||
---|---|---|---|
Line 33: | Line 33: | ||
**REGISTER 1 & 2 modes** - Each discrete input is duplicated, providing the opportunity apply two modes of initial processing and two methods of scaling. The ezeio controller' | **REGISTER 1 & 2 modes** - Each discrete input is duplicated, providing the opportunity apply two modes of initial processing and two methods of scaling. The ezeio controller' | ||
- | **Register 1 & 2 modes** - Choose one of the setting below for registers 1 & 2. | + | **Register 1 & 2 modes** - These modes control how the analog to digital converter calculates the live values. //Separate settings on the individual " |
| **Mode** | **Description** | **Effect** | | | **Mode** | **Description** | **Effect** | | ||
Line 107: | Line 107: | ||
=== Available registers === | === Available registers === | ||
+ | |||
+ | | Raw electrical value | Unit type is set by "Input hardware type", V, mA, Ohm | | ||
+ | | Raw electrical value | Unit type is set by "Input hardware type", V, mA, Ohm | | ||
+ | | Scaled value, Register 1 | Scaled by 2 point calibration | | ||
+ | | Scaled value, Register 2 | Scaled by offset and factor | | ||
+ | | Logical state | Analog value converted to digital (on/off) based on threshold setting | | ||
+ | | Logical cycles | Number of times " | ||
+ | | Logical active time | Number of seconds logical state is " | ||
+ |