ezeio2:ioexpander

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision		 Previous revision
ezeio2:ioexpander [2022-06-01 18:07] – [Model information] johparezeio2:ioexpander [2025-06-13 16:26] (current) – [Connect via EXP port] andreh
Line 81: Line 81:
   * In the first 30 seconds of start-up, press the button (at the top of the I/O Expander) 3 times   * In the first 30 seconds of start-up, press the button (at the top of the I/O Expander) 3 times
   * The I/O Expander's LEDs will begin to roll red and green. Enter the desired address by clicking the button (5 clicks = address 5)   * The I/O Expander's LEDs will begin to roll red and green. Enter the desired address by clicking the button (5 clicks = address 5)
-  * The I/O Expender's LEDs will confirm the entry by flashing the address number (5 flashes = address 5)+  * The I/O Expander's LEDs will confirm the entry by flashing the address number (5 flashes = address 5)
  
 ---- ----
Line 98: Line 98:
 In this communication mode the I/O Expander functions like a 3rd party device. Since Modbus RTU is an open protocol, it could be sold separately and use with almost any Modbus master.  In this communication mode the I/O Expander functions like a 3rd party device. Since Modbus RTU is an open protocol, it could be sold separately and use with almost any Modbus master. 
  
-  * When connecting to an ezeio via Modbus RTU a device driver is required. Search for available I/O Exp drivers on the eze.io configuration's "Device" tab or the [[ezeio2:userinterface:configuration:devices|Drivers]] section of this manual.+  * When connecting to an ezeio via Modbus RTU a device driver is required. Search for available I/O Exp drivers on the eze.io configuration's "Device" tab or the [[ezeio2:userinterface:configuration:devicelist|Drivers]] section of this manual.
   * If utilizing the I/O Expander in conjunction with a 3rd party Modbus master, refer to the I/O's [[ezeio2/ioexpander/regmap|register map]].    * If utilizing the I/O Expander in conjunction with a 3rd party Modbus master, refer to the I/O's [[ezeio2/ioexpander/regmap|register map]]. 
      
Line 128: Line 128:
   * In the first 30 seconds of start-up, press the button (at the top of the I/O Expander) 3 times   * In the first 30 seconds of start-up, press the button (at the top of the I/O Expander) 3 times
   * The I/O Expander's LEDs will begin to roll red and green. Enter the desired address by clicking the button (5 clicks = address 5)   * The I/O Expander's LEDs will begin to roll red and green. Enter the desired address by clicking the button (5 clicks = address 5)
-  * The I/O Expender's LEDs will confirm the entry by flashing the address number (5 flashes = address 5)+  * The I/O Expander's LEDs will confirm the entry by flashing the address number (5 flashes = address 5)
  
 ---- ----
  • ezeio2/ioexpander.1654106832.txt.gz
  • Last modified: 2022-06-01 18:07
  • by johpar