Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision Next revisionBoth sides next revision | ||
| ezeio2:introduction:start [2021-09-24 22:01] – ↷ Links adapted because of a move operation andreh | ezeio2:introduction:start [2021-09-24 22:03] – ↷ Links adapted because of a move operation andreh | ||
|---|---|---|---|
| Line 133: | Line 133: | ||
| Output 4 outputs an analog voltage between 0 and 10V. The software controls this in 100mV steps (0-100%). | Output 4 outputs an analog voltage between 0 and 10V. The software controls this in 100mV steps (0-100%). | ||
| - | More information about connecting to the outputs is available [[ezeio2:installation: | + | More information about connecting to the outputs is available [[ezeio2:connections: |
| === SDI-12 === | === SDI-12 === | ||
| Line 141: | Line 141: | ||
| The ezeio supports the standard SDI-12 protocol and multiple drivers are available for different types of sensors. The SDI-12 port can also be used as a generic serial input to read GPS data and other nonstandard devices. | The ezeio supports the standard SDI-12 protocol and multiple drivers are available for different types of sensors. The SDI-12 port can also be used as a generic serial input to read GPS data and other nonstandard devices. | ||
| - | More information about SDI-12 is available [[ezeio2:installation: | + | More information about SDI-12 is available [[ezeio2:connections: |
| === Modbus/RTU === | === Modbus/RTU === | ||