ezeio2:introduction:start

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
Next revisionBoth sides next revision
ezeio2:introduction:start [2021-09-24 22:01] – ↷ Links adapted because of a move operation andrehezeio2:introduction:start [2021-09-24 22:03] – ↷ Links adapted because of a move operation andreh
Line 133: Line 133:
 Output 4 outputs an analog voltage between 0 and 10V. The software controls this in 100mV steps (0-100%). Output 4 outputs an analog voltage between 0 and 10V. The software controls this in 100mV steps (0-100%).
  
-More information about connecting to the outputs is available [[ezeio2:installation:outputs|here]].+More information about connecting to the outputs is available [[ezeio2:connections:outputs|here]].
  
 === SDI-12 === === SDI-12 ===
Line 141: Line 141:
 The ezeio supports the standard SDI-12 protocol and multiple drivers are available for different types of sensors. The SDI-12 port can also be used as a generic serial input to read GPS data and other nonstandard devices. The ezeio supports the standard SDI-12 protocol and multiple drivers are available for different types of sensors. The SDI-12 port can also be used as a generic serial input to read GPS data and other nonstandard devices.
  
-More information about SDI-12 is available [[ezeio2:installation:sdi12|here]].+More information about SDI-12 is available [[ezeio2:connections:sdi12|here]].
  
 === Modbus/RTU === === Modbus/RTU ===
Line 151: Line 151:
 Several devices can be connected at the same time on the same Modbus/RTU cable. The protocol is very robust, uses low cost bulk wires and can be used in noisy environments and over long distances. Several devices can be connected at the same time on the same Modbus/RTU cable. The protocol is very robust, uses low cost bulk wires and can be used in noisy environments and over long distances.
  
-More information about Modbus/RTU is available [[ezeio2:installation:modbusrtu|here]].+More information about Modbus/RTU is available [[ezeio2:connections:modbusrtu|here]].
  
 === Modbus/TCP === === Modbus/TCP ===
Line 159: Line 159:
 The ezeio supports standard Modbus/TCP as both a 'server' and a 'client'. There are multiple drivers available for various devices. The ezeio supports standard Modbus/TCP as both a 'server' and a 'client'. There are multiple drivers available for various devices.
  
-More information about Modbus/TCP is available [[ezeio2:installation:modbustcp|here]].+More information about Modbus/TCP is available [[ezeio2:connections:modbustcp|here]].
  
 === CAN === === CAN ===
  • ezeio2/introduction/start.txt
  • Last modified: 2022-07-07 16:59
  • by andreh