Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revisionLast revisionBoth sides next revision | ||
ezeio2:installation:power [2020-12-08 03:42] – johpar | ezeio2:installation:power [2021-03-17 00:31] – andreh | ||
---|---|---|---|
Line 20: | Line 20: | ||
**Supplying power to sensors and peripherals** - The terminals in the middle, marked ' | **Supplying power to sensors and peripherals** - The terminals in the middle, marked ' | ||
- | <WRAP center round important | + | <WRAP center round important |
Only the Supply +5 & +V terminals are protected with resettable fuses that will limit the output to about 200mA. There is no fuse on the Batt +V terminal. Overloading this terminal could damage the ezeio. If your sensors require more than 200 mA or you are unsure of their current draw, bypass the ezeio' | Only the Supply +5 & +V terminals are protected with resettable fuses that will limit the output to about 200mA. There is no fuse on the Batt +V terminal. Overloading this terminal could damage the ezeio. If your sensors require more than 200 mA or you are unsure of their current draw, bypass the ezeio' | ||
</ | </ | ||
Line 42: | Line 42: | ||
=== Outputs === | === Outputs === | ||
- | The outputs | + | The outputs |