==== WattNode driver (Basic) ====

=== Description ===

This driver is designed for use with WattNode Modbus Module (WND) WattNode Modbus (WNC) and Multi-Circuit meter (MCM). This driver is included with the "Basic ezeio service" package and provides a limited set of power circuit measurements. The full set of measurements is available from the "WattNode Advanced" driver included in the "Meters" driver package.

 ----

=== Settings ===

**Name** - The name is up to the user. Our suggestion is to choose a naming convention that makes the viewing the device list intuitive. Such as referring to the sensor and/or application. Keep the name short as it will be combined with the register name to create the default "Field" name (if added to "Fields")

**Active Check box** - Check this box and "Save changes" to run the driver. The driver program can be suspended by unchecking the box and clicking on "Save changes".

**Notes** - This space can be used to store information specific to the device, such as: location, wiring, scaling, etc.

 ----

=== Meter settings ===

**Address** - Enter the RTU device number (must be unique on the bus) or the last octet of the IP address, if connected via Ethernet/TCP 

**Module** - Default setting is RTU for WattNode WND & WNC models. For Multi-Circuit Meter (MCM) select the corresponding Unit (circuit) number. 
 
**CT (A, B, & C)** - Drop-down menus are provided for selecting CT ratings for each of the three phases metered.

 ----

=== Device status ===



**Driver info** - 

**Driver updated/version** - 

**Battery & Signal** - 

**Driver status** - 

**Communication** - 

 ----

=== Available registers ===

  * Total Energy (kWh)
  * Total Power (kW)
  * Power phase A (kW)
  * Power phase B (kW)
  * Power phase C (kW)
  * Volt average ph-N (V)
  * Volt phase A-N (V)
  * Volt phase B-N (V)
  * Volt phase C-N (V)
  * Current phase A (A)
  * Current phase B (A)
  * Current phase C (A)
  * Power factor average